Cgqmin, Quality Of Service Profile (Min Acceptable) - Fibocom G510 User Manual

Example:
AT+CGDCONT?
OK // Only without any set command.
AT+CGDCONT=1, "IP","CMNET"
OK
AT+CGDCONT=2, "IP","CMWAP"
OK
AT+CGDCONT?
+CGDCONT: 1,"IP","CMWAP","0.0.0.0",0,0
+CGDCONT: 2,"IP","CMNET","0.0.0.0",0,0
OK
AT+CGACT=1
OK
AT+CGDCONT?
+CGDCONT: 1,"IP","CMWAP","10.230.50.116",0,0
+CGDCONT: 2,"IP","CMNET","10.3.97.156",0,0
OK
AT+CGDCONT=?
+CGDCONT: (1-2),("IP"),,,(0),(0,1)
OK

12.2.3+CGQMIN, Quality of Service Profile (Min Acceptable)

This command enables the terminal to specify the minimum acceptable profile which is checked by the
ME against the negotiated profile returned in the Activate PDP Context Accept message.
Command Syntax
Set AT+CGQMI
N=<cid>[,<
precedence
>[,<delay>[,
<reliability.>
[,<peak>[,<
mean>]]]]]
G5/G6-Family AT Commands User Manual
Response/Action
OK
or:
+CME ERROR: <err>
Remarks
The Set command specifies a
profile for the context identified by
the (local) context identification
parameter,<cid>. As this is the
same parameter that is used in the
+CGDCONT command, the
+CGQMIN command is effectively
an extension of the +CGDCONT
Page 189 of 243