Clip, Calling Line Identification; Clip Indication - Fibocom G510 User Manual

+CRING: VOICE
+CRING: VOICE
ath
NO CARRIER
OK

5.1.7 +CLIP, Calling Line Identification

This command controls the Calling Line Identity (CLI) presentation indication to the terminal when an
incoming call is detected by the Module.This command allows the user to query the provisioning status of
the CLI by the network and by the Module. The command also allows the user to enable/disable the CLI
presentation by the Module to the terminal. The +CLIP indication information varies depending on what is
provided by the network and what information is stored in the Module phone book.
Command Syntax
Set AT+CLIP=[<n>]
Read AT+CLIP?
Test

5.1.8 +CLIP Indication

When the CLI presentation indication is enabled by the Module (<n>=1), this unsolicited indication is sent
to the terminal after the RING indication.
+CLIP: <number>,<type>[,<subaddr>,<satype>[[,<alpha>] [,<CLI validity>]]]
The following table shows the +CLIP parameters.
<Parameter>
<n>
G5/G6-Family AT Commands User Manual
Response/Action
OK
or:
+CME ERROR:
<err>
+CLIP: <n>, <m>
OK
Description
Enables/disables the CLI presentation indication after the ring indication:
0 Disable CLI presentation
1 Enable CLI presentation
Remarks
The Set command enables or disables the
presentation of the CLI indication from the
Module to the terminal. Note: The Set
command does not address the network.
The Read command returns the +CLIP
enable/disable state in the Module as well as
in the network provisioning state of the CLI
presentation.
The Test command returns the Set command
options (0,1).
Page 46 of 243