Mci, Module Cell Information - Fibocom G510 User Manual

at+MCELL=0,22
OK
MCC:460,MNC:0,LAC:9339,Cell ID:03600,BSIC:27,(P)BCCH
ARFCN:76,RxLev:56,RxDbm:-54,C1:30,C2:30,TxPower:5,RxAccMin:6,(PD)TCH
ARFCN:INVALID_ARFCN,Timeslot:0,MAIO:0,HSN:0,Timing
Advance:255,RxQualFull:6,RxQualSub:6
at+MCELL=0,23
OK
NCELL:1,MCC:460,MNC:0,LAC:9339,Cell ID:04361,BSIC:41,(P)BCCH
ARFCN:82,RxLev:32,RxDbm:-78,C1:17,C2:13
NCELL:2,MCC:460,MNC:0,LAC:9339,Cell ID:04362,BSIC:38,(P)BCCH
ARFCN:60,RxLev:9,RxDbm:-101,C1:-1,C2:-1
9.1.8

+MCI, Module Cell Information

This command returns neighbor cell information. The command returns ARFCN, BSIC and RX level of
serving and adjacent cells. In case Module is registered, adjacent cells are from registered PLMN. In case
Module is in Emergency Mode, adjacent cells are physical neighbors. BSIC is displayed only in case SCH
(Synchronization Channel) is decoded.
The parameter <enable_TA> determines whether <TA> will be reported by +MCI command. <TA> is
defined for serving cell only. This value will be displayed only in Dedicated mode. The command output is
<Filter>dependent. In case the command output should be filtered to include just cells of a specific GSM
band (one or more) the filter parameter should be set accordingly. The filtering will apply to the neighbor's
cells only – the serving cell info will always be returned.
Using the set command without a parameter will return output according to the currently set <Filter>
value.
Command
Set
Execute
G5/G6-Family AT Commands User Manual
Syntax Response/Action
AT+MCI=<Filter OK
>[,<enable_TA
or:
>]
+CME ERROR: <err>
or:
Remarks
This command will return "OK"
only. The neighbor cell information
will return back with +MCI format
few seconds later.
Page 143 of 243