Cgdcont, Define Pdp Context - Fibocom G510 User Manual

+CGCLASS: (CC) //Note that CC is a not supported value.

12.2.2+CGDCONT, Define PDP Context

This command specifies the PDP (Packet Data Protocol) context.
Command Syntax
Set AT+CGDCONT=[<cid>
[,<PDP_type>[,<APN>
[,<PDP_addr>[,<d_co
mp>[,<h_comp>]]]]]]
Read AT+CGDCONT?
Test AT+CGDCONT=?
The following table shows the +CGDCONT parameters.
<Parameter>
G5/G6-Family AT Commands User Manual
Response/Action
OK
or:
+CME ERROR: <err>
+CGDCONT:
<cid>,<PDP_type>,<APN>,
<PDP_addr>,<data_comp>
,<head_comp>[<CR><LF>
+CGDCONT:
<cid>,<PDP_type>,<APN>,
<PDP_addr>,<data_comp>
,<head_comp>
OK
+CGDCONT: (range of
supported <cid>s),
<PDP_type>, , , (list of
supported <d_comp>s),
(list of supported
<h_comp>s)
OK
Description
Remarks
The Set command specifies the
context identification parameter
values for a PDP context. A
special form of the Set
command, +CGDCONT= <cid>
causes the values for context
number <cid> to become
undefined.
The read command returns the
current settings for each defined
context.
It will be read only "OK" without
any set command.
The Test command returns the
values supported as a
compound value. If the ME
supports several PDP types,
<PDP_type>, the parameter
value ranges for each
<PDP_type> are returned on a
separate line.
Page 187 of 243