Modem Control And Status; Modem Register Commands; V, Module Response Format - Fibocom G510 User Manual

4 Modem Control and Status

4.1 Modem Register Commands

The module holds certain data items in selected memory space, named Software Registers (S-registers)
and Modem Registers. Some of these registers are used as bitmaps, where one register holds more than
one data item.
All S-registers can be accessed using the S command, described in "S, Bit Map Registers". Some
registers can also be accessed using dedicated commands, detailed below.

4.1.1 V, Module Response Format

This command determines the response format of the data adapter and the contents of the header and
trailer transmitted with the result codes and information responses. This command also determines
whether the result codes are transmitted in a numeric or an alphabetic ("verbose") form. The text portion
of information responses is not affected by this setting.
The following table shows the effect that setting this parameter has on the format of information text and
result codes.
V0
<ATV0><cr><lf>
<numeric code><cr>
Command
Set
G5/G6-Family AT Commands User Manual
V1
<ATV1><cr><lf>
<verbose code><cr><lf>
Syntax Response/Action
ATV<value> OK
Information Responses
0 - "OK"
1 - "CONNECT"
2 - "RING"
3 - "NO CARRIER"
4 - "ERROR"
5 - "NO DIALTONE"
6 - "BUSY"
7 - "NO ANSWER"
8 - "NOT SUPPORT"
9 - "INVALLID COMMAND LINE"
10 - "\r\n"
Remarks
The Set command sets the format
Page 22 of 243