Mipconf - Configure Internal Tcp/Ip Stack - Fibocom G510 User Manual

13.1.13 +MIPCONF - Configure Internal TCP/IP Stack

This command allows configuring TCP stack parameters, such as re-transmissions number, upper and
bottoming limits of re-transmission timeout, close delay. It can be used to configure TCP socket
parameters before socket activation. Configuration values will be stored in Module until power circle.
This command must used under MIPCALL is enabled.
Command Syntax
Set AT+MIPCONF=<socket_I
D>[[,<retr_num>][,<min_T
O>][,<max_TO>][,<max_c
lose_delay>]
[,<is_nack_ind_req>]]
Read +MIPCONF?
Test +MIPCONF=?
AT Commands User Manual
Response/Action
OK
or:
+CME ERROR: <err>
+MIPCONF:
1,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
+MIPCONF:
2,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
+MIPCONF:
3,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
+MIPCONF:
4,<retr_num>,<min_TO>,<max_TO>,<m
ax_close_delay>,<is_nack_ind_req><C
R><LF>
OK
+MIPCONF:
(1-4),(1-12),(1-10),(10-600),(1-75),(0-2)
OK
Remarks
The Set updates
TCP stack
configuration
parameters.
The read
command
returns current
settings of TCP
stack
parameters.
The Test
command
returns the
possible
parameters
Page 215 of 243