D>, Direct Dialing From Phone Books - Fibocom G510 User Manual

Example:
atd44345678;
OK
OK
atd44345678
OK
OK
5.1.2 D>, Direct Dialing from Phone Books
This command places a VOICE call on the current network by dialing directly from the Module phone
book.
Note:
 "+CME ERROR: not found" is returned when no match is found in an existing phone book.
 FD phone book supports the (?) wild card character. Telephone numbers containing this character
cannot be dialed directly from the phone book.
"+CME ERROR: Invalid index" is returned when entry <n> is out of the requested Phonebook range.

 When SM phonebook is searched and the given entry value is of the ME phonebook, ME phonebook
will be searched as well (result code would be the same as if MT phonebook was searched).
The following table shows a detailed description for the D> commands.
Command
D><alpha>[;]
D>"mem"<n>[;]
D><n>[;]
Note: Current used memory (phone book) set/read is done through the memory command
+CPBS=/+CPBS? respectively.
The following table shows the D> parameters.
<Parameter>
<"alpha">
G5/G6-Family AT Commands User Manual
//VOICE call (with semicolon)
//VOICE call (with semicolon)
Detailed Description
Originates a call to a phone number with the corresponding alphanumeric
field <alpha>. The Current Phone Book (Set by +CPBS) is searched for the
entry that begins with the alphanumeric pattern <alpha>.
Originates a call to a phone number in memory (phone book) mem and
stored in entry location <n>.
Originates a call to a phone number from entry location <n> in the Current
Phone Book (Set by +CPBS).
Description
String type value, which should be equal to an alphanumeric field in a phone
Page 40 of 243