Mstart, Start Message Notification - Fibocom G510 User Manual

4.4 +MSTART, Start message notification

This command can Enable/Disable module output start message when power up.
Command Syntax
Set +MSTART=<at start>,<sim ready>
Read + MSTART?
Test +MSTART=?
The following table shows the +MSTART parameters.
<Parameter>
<at start>
<sim ready>
Example:
AT+MSTART=?
+MSTART: (0,1),(0,1)
OK
AT+MSTART=1,1
OK
AT+MSTART?
+MSTART: 1,1
OK
G5/G6-Family AT Commands User Manual
Description
0: Do not output "AT command ready" from UART
1: Output "AT command ready" from UART (default value)
0: Do not output "+SIM READY" after SIM init OK
1: Output "+SIM READY" after SIM init OK (default value)
Response/Action
OK
or:
ERROR
+MSTART: <at start>,<sim ready>
OK
+MSTART: (0-1,0-1)
OK
Page 38 of 243