Uart2 Use For At Command - Fibocom G510 User Manual

The data format is in hex. As the input command can only be character, so here use two characters to
indicate one hex number. E.g.: "35" means 0x35. Module will change the format internally.
Command
Set
Test
The following table shows the +UARTSEND parameters.
<Parameter>
<source>
<data>
Example:
AT+UARTSEND=2,"30313233"
OK
AT+UARTSEND=?
+UARTSEND: (2),("data")

10.2.4UART2 use for AT Command

When use for AT command. It supports the following AT commands only:
CFSN
CGMI
CGMM
CGMR
CGREG
CGSN
G5/G6-Family AT Commands User Manual
Syntax Response/Action
AT+UARTSEND= OK
<source>,<data>
Or:
+CME ERROR: <err>
AT+UARTSEND= +UARTSEND:
?
<source>,<data>
OK
or
ERROR
Description
1 (For internal reason 1 indicates UART1 here)
2(For internal reason 2 indicates UART2 here)
0-F (The data should be wrap up with "", and the valid character is
0-F)
//UART2 will output "0123"
Remarks
Used to send data to
UART2.
Return supported values
Page 172 of 243