Miprudp, Receive Data From Udp Protocol Stack; Miprtcp, Receive Data From Tcp Protocol Stack - Fibocom G510 User Manual

AT+MIPFLUSH=2
command
+MIPFLUSH: 2
OK
AT+MIPFLUSH=5
ERROR
AT+MIPFLUSH?
+MIPFLUSH: 1, 2
OK

13.1.9+MIPRUDP, Receive Data from UDP Protocol Stack

This unsolicited event is sent by the Module to the terminal when data is received from the UDP protocol
stack.
Set Command Event
+MIPRUDP: <Source_IP>,<Source_Port><socket_ID>,<Left>,<Data>
The following table shows the +MIPRUDP parameters.
<Parameter>
Source_IP
Source_Port
Socket_ID
Left
Data
Example:
+MIPRUDP: 172.16.3.135,222,2,0,44444444

13.1.10 +MIPRTCP, Receive Data from TCP Protocol Stack

This unsolicited event is sent by the Module to the terminal when data is received from the TCP protocol
stack.
Set Command Event
+MIPRTCP: <socket_ID>,<Left>,<Data>
AT Commands User Manual
//Socket number 2 was previously opened using the +MIPOPEN
Description
IP of the source
Port of the source
1,2,3,4 - Number of valid sockets.
Size of received Data still left in protocol stack.
Data string received with 0-F hexadecimal digits. String ends with a
<CR>.
Page 212 of 243