S, Bit Map Registers - Fibocom G510 User Manual

4.1.4 S, Bit Map Registers

This command reads/writes values of the S-registers. The module supports this command for various S
values, according to official specifications (ITU-I, ETSI, or manufacturer specific).
Command
Set
Read
Test
The following table shows the different S-registers and their associated values.
Sn Description
S0 Sets/gets number of rings before auto answer.
S3 Sets/gets carriage return code character.
S4 Sets/gets line feed code character.
S5 Sets/gets command line editing character(backspace).
S12 Sets/gets guard time (in units of 50 msec) for the
escape character during ODM connections
Note: S0 (Auto Answer) should work regardless of the DTR HW line state. This is a deviation from the
ITU V. 25-ter standard.
Example:
ATS0?
000
OK
G5/G6-Family AT Commands User Manual
Syntax Response/Action
ATSn=<value> OK
or:
+CME ERROR: <err>
ATSn? <current value of
S-register n>
OK
or:
+CME ERROR: <err>
Remarks
The Set command is allowed for
read/write S-registers, and not
allowed for read-only S-registers.
The Test command for Sn is not
defined by ITU, and therefore is not
supported by the Module. The G5xx
returns an error.
Min Max
0 255
0 127
0 127
0 127
0 255
Default
0
13
10
8
50
Page 25 of 243