Cmss, Send Message From Storage - Fibocom G510 User Manual

OK
AT+CPMS="SM"
+CPMS: 2,20,11,61,2,20
OK
AT+CMGR=1
+CMGR: "REC READ","+972544565034",,"05/02/23,11 : 20:
10+08",145,4,0,4,"+97254120032",145,4 41424344
OK
AT+CMGF=0
OK
AT+CMGR=1
+CMGR: 0,,23
0791 07917952140230F2040C917952446505430004502032110201800441424344
OK
AT+CMGR=14
+CMGR: 0,,25
079179521201009506BC0B917952428600F0508030807512805080308075128046
// SMS-STATUS-REPORT message in PDU mode
OK
AT+CMGF=1
OK
AT+CMGR=14
+CMGR: "REC READ",6,188,"+97252468000",145,"05/08/03,08: 57: 21+08","05/08/03,08: 57:
21+08",70
OK

7.1.13 +CMSS, Send Message from Storage

This command sends a pre-stored message, written previously using the +CMGW command. The <da>,
<toda> parameters are optional. If a DA is given, the message is sent to that address. Otherwise the
message is sent to the DA it was stored with (if any was entered). If no DA is found, an error occurs.
When the given index is an incoming message index the header settings will be as follows:
 <first-octet> will be SMS-SUBMIT and VPF - relative.
 The TP-RP and TP-UDHI settings will be taken from the incoming message's first octet.
<vp> - will be set to the default value -167 - as defined in 03.40.

 <sca>,<tosca>, <pid> and <dcs> will be set according the incoming message parameters.
If <da> and/or <toda> are not given by the command, the <oa> and <tooa> will be set instead.

Command
Set
G5/G6-Family AT Commands User Manual
// change to SM to read SMS-DELIVER messages.
// SMS-STATUS-REPORT message in Text mode
Syntax Response/Action
+CMSS=<i +CMSS: <mr>
Remarks
The Set command sends a message
Page 109 of 243