Z, Reset To Default Configuration; W, Store User Profile - Fibocom G510 User Manual

Example:
AT&F?
&F: 0
OK

4.1.8 Z, Reset to Default Configuration

This command drops the current call, and resets the values to default configuration.
Command
Set
Read
Test
The following table shows the Z parameters.
<Parameter>
<value>
Example:
ATZ0
OK
4.1.9 &W, Store User Profile
This command saved the active profile to one of two user profiles.
Note: The user must power off the module in regular process. Otherwise, this command cannot be in
G5/G6-Family AT Commands User Manual
Syntax Response/Action
ATZ<value> OK
or:
+CMS ERROR:
<err>
Description
0 Set to user profile 0
The default value is 0.
Remarks
The Read command for Z is not defined,
and therefore is not supported by the
Module. The Module returns an error.
The Test command for Z is not defined, and
therefore is not supported by the Module.
The Module returns an error.
Page 28 of 243