Icf, Dte-Dce Character Framing - Fibocom G510 User Manual

OK
AT+COPS?
+COPS: 0,0,"CHINA MOBILE"
OK
10.1.11

+ICF, DTE-DCE Character Framing

This command determines the local serial port start/stop (asynchronous) character framing used by the
DCE when accepting DTE commands and transmitting information text and result codes, whenever these
are not done automatically. Auto detect framing is not supported.
Command Syntax
Set +ICF=[<format>[,<p
arity>]]
Read +ICF?
Test +ICF=?
The following table shows the +ICF parameters.
<Parameter>
<format>
<parity>
G5/G6-Family AT Commands User Manual
Response/Action
OK
+CME ERROR: <err>
+ICF: <format>,<parity>
+CME ERROR: <err>
+ICF:(list of supported
<format> values),(list of
supported <parity>
values)
+CME ERROR: <err>
Description
Determines the number of bits in the data bits, the presence (or absence)
of a parity bit, and the number of stop bits in the start/stop frame.
1 8 Data, 2 St–p - can be set only with <parity> 4
2 8 Data, 1 Parity, 1 Stop - can be set with <parity> of 0 or 1
3 8 Data, 1 Stop (default) - can be set only with <parity> 4
5 7 Data, 1 Parity, 1 Stop - can be set with <parity> of 0 or 1
7 8 Data, 1 Parity, 2 Stop - can be set with <parity> of 0 or 1
8 7 Data, 1 Parity, 2 Stop - can be set with <parity> of 0 or 1
Determines how the parity bit is generated and checked (if present).
0 Odd
Remarks
The Set command determines the
local serial port start/stop character
framing.
The Read command displays the
currently selected character framing.
The Test command displays a list of
supported <format> and <parity>
values.
Page 166 of 243