Mmicg, Microphone Gain Value; Matone，Start Or Stop The Tone Play,And The Tone Plays Only Once - Fibocom G510 User Manual

11.2.11+ MMICG, Microphone Gain Value

This command handles the selection of microphone gain values of MIC-handsets and MIC-headsets. The
new value remains after power cycle.
Command
Set
Read
Test
The following table shows the +MMICG parameters.
<Parameter>
<gain>
11.2.12 +MATONE，Start or stop the tone play,and the tone plays
only once
Command
Set
Read
Test
G5/G6-Family AT Commands User Manual
Syntax Response/Action
+MMICG=<gai OK
n>
or:
+CME ERROR: <err>
+MMICG? +MMICG: <gain>
OK
+MMICG=? +MMICG: (list of
supported <gain>s)
OK
Description
Microphone gain values:
0-15 0 is lowest gain value (not mute); The default value is 8.
Syntax
+MATONE=<state>,<tone_i
d>,<mix_fac
tor>,<play_time>
+MATONE?
+MATONE=?
Remarks
The Set command sets the
microphone gain value.
The Read command displays the
current microphone gain.
The Test command displays the list
of supported gain values.
Response/Action
OK
or:
+CME ERROR: <err>
+CME ERROR: <err>
+ MATONE:
<state>,<tone_id>,<mix_factor>,<play_time>
OK
Page 183 of 243