Clcc, List Current Calls - Fibocom G510 User Manual

The following table shows the +CPAS parameters.
<Parameter>
<pas>
Example:
AT+CPAS
+CPAS: 0
OK
AT+CPAS=?
+CPAS: (0-5)
OK
AT+CPAS?
+CPAS: 4
OK
AT+CPAS//Voice call active state
+CPAS: 4
OK

5.2.2 +CLCC, List Current Calls

This command displays a list of all current Module calls and their statuses, and also enables/disables the
unsolicited indication of the call list. (If no calls are received, no information response is sent to the
terminal.)
If the command succeeds but no calls are available, no information response is sent to the terminal.
The maximum number of simultaneous multiparty calls is 5+1 (5 in active group and 1 on hold).
Command Syntax
Set AT+CLCC=<state>
G5/G6-Family AT Commands User Manual
Description
0 - Ready - The Module allows commands from the terminal
1 - unavailable(MT does not allow commands from TA/TE)
2 - Unknown - The Module is not guaranteed to respond to instructions
3 - Ringing (MT calls) - The Module is ready for commands from the terminal,
but the ringer is active
4 - Call in progress - The Module is ready for commands from the terminal, but a
call is in progress
5 – Asleep (MT is unable to process commands from TA/TE, because it is in a
low functionality state.
Response/Action
OK
Remarks
The Set command enables/disables
unsolicited indications.
Page 62 of 243