Mhup, Module Hung Up Call - Fibocom G510 User Manual

AT+MDC=?
+MDC: (0-1)
OK
AT+MDC=1
OK
ATD<number>;
OK
CONNECT
AT+MDC?
+MDC: 1
OK
AT+MDC=0
OK
ATD<number>;
OK
OK
AT+MDC?
+MDC: 0
OK

5.1.17+MHUP, Module Hung UP call

This command hung up a specific call or all calls, and reports a specific disconnect cause to the NW.
Command
Set
Test
The following table shows the +MHUP parameters.
<Parameter>
<cause>
G5/G6-Family AT Commands User Manual
Syntax Response/Action
AT+MHUP=< OK
cause>[,<call
or:
_id>]
+CME ERROR: <err>
AT+MHUP=? +MHUP:
(1,16,17,18,27,31),(0-7)
OK
Description
Cause description, send to the NW in the "disconnect" message.
1 "Unassigned (unallocated) number"
Remarks
Show list of supported <cause>'s
and list of supported <call_id>'s.
Page 60 of 243