Cgact, Pdp Context Activate Or Deactivate - Fibocom G510 User Manual

12.2.7+CGACT, PDP Context Activate or Deactivate

This command activates/deactivates the specified PDP context(s).
Command Syntax
Set AT+CGACT=
[<state>[,<ci
d>[,<cid>[,]]]]
Read AT+CGACT?
Test AT+CGACT=
?
G5/G6-Family AT Commands User Manual
Response/Action Remarks
OK The Set command activates/deactivates the
specified PDP context(s). When the command is
or:
completed, the ME remains in V.25 command
NO CARRIER
state. If any PDP context is already in the
or: requested state, the state for that context
remains unchanged. If the requested state for
+CME ERROR:
any specified context cannot be achieved, an
<err>
ERROR or +CME ERROR response is returned.
Extended error responses are enabled by the
+CMEE command. If the ME is not
GPRS-attached when the activation form of the
command is executed, the ME first performs a
GPRS attach and them attempts to activate the
specified contexts. If the attach fails, the ME
responds with an ERROR or, if extended error
responses are enabled, with the appropriate
failure-to-attach error message.
+CGACT: The Read command returns the current
<cid>,<state><CR> activation states for all the defined PDP
<LF> contexts.
+CGACT:
<cid>,<state><CR>
<LF>
+CGACT:
<cid>,<state>
OK
+CGACT: (list of The Test command requests information on the
supported supported PDP context activation states.
<state>s)
OK
Page 196 of 243