Mrst, Perform Hardware Power Down; Wrim, Ri Signal Width Setting - Fibocom G510 User Manual

Example:
AT+ICF?
+ICF: 3,4
OK
AT+ICF=?
+ICF: (1-3,7),(0,1,4)
OK
AT+ICF=3,1
OK

10.1.12 +MRST, Perform Hardware power down

The +MRST command enables customer software to perform a hardware power down to the Module unit.
This command provides a software power-off without network logging off.
Command Syntax
Set +MRST
Example:
AT+MRST
OK
// Result - Module performs a power down

10.1.13 +WRIM, RI signal width setting

In IDLE Mode, Module's RI pin is High voltage level. When Module receive a SMS or Call, This pin can
output a Low voltage pulse. This command defines the width of pulse can be set.
Command Syntax
Set +WRIM=<type>,<wi
dth>
G5/G6-Family AT Commands User Manual
1 Even
4 No parity (default)
Response/Action Remarks
OK The Set command performs a graceful hardware
power down to the Module.
Note: The Read and Test commands are not
permitted for the +MRST command.
Response/Action
OK
or:
Remarks
Set width
Page 167 of 243