E, Command Echo - Fibocom G510 User Manual

Example:
ATQ0
OK
ATQ?
Q: 0
OK
ATQ4
ERROR
ATQ1 //No response because result codes are suppressed.
ATQ4 //No response because result codes are suppressed.

4.1.3 E, Command Echo

This command defines whether input characters are echoed to output. If so, these characters are echoed
at the same rate, parity and format at which they were received.
Command
Set
Read
The following table shows the E parameters.
<Parameter>
<value>
Example:
ATE?
001
OK
G5/G6-Family AT Commands User Manual
Syntax Response/Action
ATE<value> OK
or:
+CME ERROR: <err>
ATE? <value>
OK
Description
000 Does not echo characters
001 Echoes characters
The default value is 1.
Remarks
The Set command sets whether or
not to echo characters.
The Test command for E is not
defined by ITU, and therefore is not
supported by the module. The
module returns an error.
Page 24 of 243