When Relocating The Machine - Canon imageRUNNER ADVANCE C3325 Series Service Manual

When Relocating the Machine

When relocating this machine by truck or by other means for some reasons after installing the
machine, perform the following procedure.
CAUTION:
In case of relocating the machine while it is mounted on the Cassette Pedestal, be sure
to check that the coin screw has been tightened securely before holding the grips of the
machine to lift when, for example, passing over a difference in level of the floor. Holding
the grips of the machine when lifting will result in separation of the machine from the
Cassette Pedestal.
1) Move the Scanner Unit to the position where it is going to be secured.
• Service Mode (Level 2) > COPIER > Function > MISC-R > RD-SHPOS
2) Turn OFF the main power.
3) Disconnect the power plug of the host machine.
4) f the Cassette Pedestal is installed, turn the 3 adjusters of the Cassette Pedestal with a
screwdriver, etc. to lift them from the floor.
5) Secure the Scanner Unit with the Scanner System Fixation Screws that have been kept in
a safe place since installation.
6) Put a sheet of paper on the Copyboard Glass.
9
Installation > When Relocating the Machine
7) After turning ON the power, make a copy.
8) Securely tighten the coin screws of the host machine and the 2-cassette Pedestal.
CAUTION:
• When tightening the coin screws, pay attention to plates and parts around the
• When tightening a screw on the rear side, be careful not to drop it.
• Be sure to check that the coin screws have been tightened securely.
2x
F-9-65
9 Installation > When Relocating the Machine
screws.
1x
9-32
1x
1x
F-9-66
9-32