4)
NOTE:
•
Connect the connector to J14 (11-pin), and install the Serial RS Conversion Board.
•
Use the screws removed in steps 1 and 2.
4x
9
Installation > Serial Intreface KIT-K2/ Copy Control Interface KIT-A1 > Installation Procedure > Installing the Copy Control Interface Kit
1x
F-9-259
9
Installation > Serial Intreface KIT-K2/ Copy Control Interface KIT-A1 > Installation Procedure > Installing the Copy Control Interface Kit
■ Installing the Copy Control Interface Kit
1)
NOTE: Remove the Face Plate while holding it.
•
1 Screw (upper) (Remove)
•
1 Screw (lower) (to loosen)
CAUTION:
Be careful not to drop the Face Plate.
1x
1x
9-105
F-9-260
9-105