Canon imageRUNNER ADVANCE C3325 Series Service Manual page 623

COPIER>ADJUST>PASCAL
OFST-P-K Bk density adj at test print reading
Lv.1 Details To adjust the offset of Bk color test print reading signal at Auto Adjust
Gradation (Full Adjust).
When replacing the Scanner Unit/clearing the RAM data of the
Reader Unit, enter the value of service label.
As the greater value is set, the image after adjustment gets darker.
Use case • When replacing the Scanner Unit
• When clearing the RAM data of the Reader Unit
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -128 to 128
Default value According to the adjustment value of the Reader at factory shipment
8
Service Mode > COPIER > ADJUST > COLOR
T-8-26
8 Service Mode > COPIER > ADJUST > COLOR
■ COLOR
COPIER>ADJUST>COLOR
ADJ-Y Adjustment of color balance for Y-color
Lv.1 Details To adjust the default value of the color balance for Y-color when the
density of Y-color varies between devices.
As the value is larger, the image gets darker. If the value is too large,
a transfer failure and/or a fixing failure occurs.
Use case Upon user's request (to reduce density difference between devices)
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range -8 to 8
Default value 0
ADJ-M Adjustment of color balance for M-color
Lv.1 Details To adjust the default value of the color balance for M-color when the
density of M-color varies between devices.
As the value is larger, the image gets darker. If the value is too large,
a transfer failure and/or a fixing failure occurs.
Use case Upon user's request (to reduce density difference between devices)
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range -8 to 8
Default value 0
ADJ-C Adjustment of color balance for C-color
Lv.1 Details To adjust the default value of the color balance for C-color when the
density of C-color varies between devices.
As the value is larger, the image gets darker. If the value is too large,
a transfer failure and/or a fixing failure occurs.
Use case Upon user's request (to reduce density difference between devices)
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range -8 to 8
Default value 0
ADJ-K Adjustment of color balance for Bk-color
Lv.1 Details To adjust the default value of the color balance for Bk-color when the
density of Bk-color varies between devices.
As the value is larger, the image gets darker. If the value is too large,
a transfer failure and/or a fixing failure occurs.
Use case Upon user's request (to reduce density difference between devices)
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range -8 to 8
Default value 0
8-72
8-72