Host Machine Settings (Starting The Setup Guide) - Canon imageRUNNER ADVANCE C3325 Series Service Manual

5)
6) Turn ON the main power switch.
NOTE: How to Turn OFF the Main Power
1) Turn OFF the main power switch.
2) Check that display in the Control Panel and the lamp of the main power are turned
off, then disconnect the power plug.
9
Installation > imageRUNNER ADVANCE C3300 > Host Machine Settings (Starting the Setup Guide)

Host Machine Settings (Starting the Setup Guide)

CAUTION:
• The Setup Guide screen appears when the power is turned ON for the first time
• It is not possible to exit Setup Guide halfway through.
• Setup Guide can be started again from [Settings/Registration] ( [Settings/
• What has been registered in Setup Guide can be changed from items in (Settings/
F-9-49
CAUTION: Register the information of
paper loaded during installation of the host machine.
Be sure to register the correct paper type. Especially in the case of special paper types
such as heavy paper, registering a wrong paper type may result in image failure, and
when the Fixing Assembly becomes soiled or paper wraparound occurs, repair by a
service technician becomes necessary.
NOTE:
•
•
9 Installation > imageRUNNER ADVANCE C3300 > Host Machine Settings (Starting the Setup Guide)
after the machine is installed. Follow the instructions displayed on the Touch Panel
Display to configure the settings of the host machine.
Registration] > [Management Settings] > [License/Other] > [Start Setup Guide]).
Registration). When configuring settings using Setup Guide, excluding some of
the setting items, it is possible to proceed to the next setting without entering the
current setting. To configure skipped settings, configure the settings one by one
after exiting Setup Guide. If the host machine is turned OFF during registration
using Setup Guide, Setup Guide is automatically started by turning ON the power
again. Once registration using Setup Guide has been completed, Setup Guide is not
automatically started by turning ON the host machine.
Initialization of toner supply, initialization of the Developing Unit, initialization of the drum,
and color displacement correction, etc. are automatically performed while Setup Guide is
running.
When all initializations have been completed, Setup Guide stops (approx.4 minutes).
9-21
9-21