Canon imageRUNNER ADVANCE C3325 Series Service Manual page 757

■ NETWORK
COPIER>TEST>NETWORK
PING Checking of network connection
Lv.1 Details To check connection between the machine and TCP/IP network.
Use case - When checking network connection at the time of installation
- At network connection failure
Adj/set/operate method 1) Turn OFF the main power switch.
2) Connect the network cable to the machine, and then turn ON the
main power switch.
3) Inform the system administrator at user's site that installation of
the machine is complete, and ask for network setting.
4) Ask the system administrator to check the network connection,
and check the remote host address of PING destination.
5) Select the item and enter the remote host address, and then press
OK key and Start key.
OK: Connection is normal. Checking procedure is complete.
NG: Connection failed. Go to step 6) if the cable connection is OK. In
case of cable connection failure, connect again and then go to step 5).
6) Select the item and enter loopback address, and then press OK
key and Start key.
OK: TCP/IP setting of this machine is normal. Go to step 7) to check
NIC.
NG: TCP/IP setting of this machine has failure. Go to step 3) to
check the setting again.
7) Select the item and enter the local host address, and then press
OK key.
OK: Network setting of this machine and NIC are normal. Inform the
system administrator that the trouble is due to network environment
and ask for countermeasure.
NG: Connection failure/fault with NIC. Check connection of NIC/
replace NIC.
Display/adj/set range 0.0.0.0 to 255.255.255.255
At normal state: OK, At failure occurrence: NG
Supplement/memo - Remote host address: IP address of PC terminal in network.
- Loopback address: 127.0.0.1. Checking TCP/IP of this machine is
available because the signal is returned before NIC.
- NIC: Network interface board
- Local host address: IP address of the machine
IPV6-ADR Setting of PING destination IPv6 address
Lv.1 Details To set the IPv6 address to send PING.
When PING-IP6 is executed, PING is sent to the address.
Use case At network connection via IPv6
Adj/set/operate method Enter the setting value, and then press OK key.
Caution - Enter a consistent character string as an IPv6 address.
- Enter an address within 39 characters including hexadecimal
numbers (0 to 9, a to f) and a separator (:).
Related service mode COPIER> TEST> NETWORK> PING-IP6
8
Service Mode > COPIER > TEST > NETWORK
8 Service Mode > COPIER > TEST > NETWORK
COPIER>TEST>NETWORK
PING-IP6 PING transmission to IPv6 address
Lv.1 Details To send PING to the IPv6 address specified by IPV6-ADR.
Whether the machine is connected to the IPv6 network environment
can be checked.
Use case At network connection via IPv6
Adj/set/operate method Select the item, and then press OK key.
Display/adj/set range At normal termination: OK, At abnormal termination: NG
Related service mode COPIER> TEST> NETWORK> IPV6-ADR
8-206
T-8-63
8-206