Canon imageRUNNER ADVANCE C3325 Series Service Manual page 665

COPIER>ADJUST>EXP-LED
INTEXP-M Adj Cln Pre-expo LED(M) initial intnsty
Lv.2 Details To adjust the initial light intensity of the Cleaning Pre-exposure LED (M).
When replacing the LED, enter the value written on the label included
in the package of a new one.
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Use case • When replacing the Cleaning Pre-exposure LED
• When replacing the DC Controller PCB/clearing RAM data
Adj/set/operate method Enter the setting value, and then press OK key.
Caution Use this item only when replacing the Cleaning Pre-exposure LED or
replacing the DC Controller PCB/clearing RAM data.
Display/adj/set range 0 to 100
Unit 1 %
Default value 0
INTEXP-C Adj Cln Pre-expo LED(C) initial intnsty
Lv.2 Details To adjust the initial light intensity of the Cleaning Pre-exposure LED (C).
When replacing the LED, enter the value written on the label included
in the package of a new one.
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Use case • When replacing the Cleaning Pre-exposure LED
• When replacing the DC Controller PCB/clearing RAM data
Adj/set/operate method Enter the setting value, and then press OK key.
Caution Use this item only when replacing the Cleaning Pre-exposure LED or
replacing the DC Controller PCB/clearing RAM data.
Display/adj/set range 0 to 100
Unit 1 %
Default value 0
INTEXP-K Adj Cln Pre-expo LED(Bk) initial intnsty
Lv.2 Details To adjust the initial light intensity of the Cleaning Pre-exposure LED
(Bk).
When replacing the LED, enter the value written on the label included
in the package of a new one.
When replacing the DC Controller PCB/clearing RAM data, enter the
value of service label.
Use case • When replacing the Cleaning Pre-exposure LED
• When replacing the DC Controller PCB/clearing RAM data
Adj/set/operate method Enter the setting value, and then press OK key.
Caution Use this item only when replacing the Cleaning Pre-exposure LED or
replacing the DC Controller PCB/clearing RAM data.
Display/adj/set range 0 to 100
Unit 1 %
Default value 0
8
Service Mode > COPIER > ADJUST > EXP-LED
T-8-32
8 Service Mode > COPIER > ADJUST > EXP-LED
8-114
8-114