Canon imageRUNNER ADVANCE C3325 Series Service Manual page 725

COPIER > OPTION > NETWORK
Lv.2 Details To set the number of packets for participating in VLAN.
Three sets of packets multiplied by the setting value are sent.
When VLAN-SW is 1, this setting is enabled.
Use case When participating in dynamic VLAN
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 10
Default value 1
Related service mode COPIER> OPTION> NETWORK> VLAN-SW
Supplement/memo - VLAN (Virtual LAN): A method for realizing grouping of terminals
depending on the hub, switch connection port, MAC address, protocol,
etc.
- If IP address of the machine has not been set, an IP address is
assigned after participating in VLAN.
FTPMODE Set of FTP print default operation mode
Lv.1 Details To set the default operation mode of FTP print.
Switch the default operation mode between ASCII mode and BIN
mode in accordance with user's environment.
Use case When preferring to switch the default operation mode of FTP print
according to the user's environment at installation
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: ASCII mode, 1: BIN mode
Default value 0
SSLMODE Setting of HTTP/HTTPS port open/close
Lv.2 Details To set whether to open or close HTTP/HTTPS port.
When 1 is set while [Use HTTP] is ON and [SSL Settings] is OFF in
Settings/Registration menu, HTTP port is opened whereas HTTPS
port is closed.
When 2 is set while both [Use HTTP] and [SSL Settings] are ON in
Settings/Registration menu, HTTP port is closed whereas HTTPS port
is opened.
Use case When limiting the port to open because of security concern
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 2
0: Normal, 1: Open HTTP port (80/8000) only, 2: Open HTTPS port
(443/8443) only
Default value 0
Related user mode Preferences> Network> TCP/IP Settings> Use HTTP
Management Settings> License/Other> MEAP Settings> SSL Settings
SSLSTRNG Allow weak encryption algorithm for SSL
8
Service Mode > COPIER > OPTION > NETWORK
8 Service Mode > COPIER > OPTION > NETWORK
COPIER > OPTION > NETWORK
Lv.2 Details To set whether to allow using weak encryption algorithm for SSL.
When 1 is set, weak encryption algorithm cannot be used.
Use case When prohibiting weak encryption algorithm because of security
concern
Adj/set/operate method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/adj/set range 0 to 1
0: Normal mode, 1: Secured mode (TLS_RSA_WITH_RC4_128_SHA
and TLS_RSA_WITH_RC4_128_MD5 are not used)
Default value 0
8-174
8-174