Canon imageRUNNER ADVANCE C3325 Series Service Manual page 933

<In case of USB flash drive>
1) Connect the USB memory to the PC.
2) Start up SST, and click the USB icon displayed in the target selection screen.
3) Select the drive, the model series, and the version to be written to the USB flash drive, and
click [Confirm].
4) Click [Start], and after the version has been written to the USB flash drive, click [OK] and
then remove the USB flash drive.
5) Terminate the SST.
6) Connect the USB memory device to the host machine, and start the host machine with
download mode in safe mode.
7) Press keys on the Control Panel in the order shown below.
• Press any keys
• [4] : Clear/Format
• [1] : Disk Format
• [0] : OK
• Press any keys
• [C] : Return to Menu
• [Reset] : Start shutdown sequence
• [0] : OK (The power of the host machine is turned OFF automatically.)
8) Remove the USB flash drive.
9) Turn ON the main power switch.
Checking the Security Version
1) Press the Counter Check key on the control panel.
2) Press the [Check Device Configuration] key appearing on the control panel.
3) Confirm that '2.01' is displayed for the [Canon MFP Security Chip] item indicating the
version of the security chip.
If multiple Encryption Boards are installed, the version information for each board is
displayed.
CAUTION:
The user can refer to the version displayed in the [Canon MFP Security Chip] item
indicating the version of the security chip to confirm that an Encryption Board that
contains a security chip version that has received CC certification is operating correctly.
Checking the Security Mark
The user can check the security mark displayed on the Control Panel when using the host
9
Installation > TYPE-3: HDD Data Encryption Kit/ Removable HDD Kit Installation Procedure > Informing the System Administrator That Installatio
machine to confirm that security is being protected. This security mark is displayed only
when an Encryption Board is installed and operating normally. The location where the
security mark is displayed is described in the User's Guide as shown below.
< Confirming the Security Mark >
When the HDD Data Encryption Kit is operating normally, a security mark (
displayed on the lower left corner of a panel screen.
Informing the System Administrator That Installation Is
Complete
• When installation is complete, give the following explanation to the system administrator.
• When installation is complete, inform the system administrator that the security functions
have been added, and explain the procedure for checking whether the security functions
are enabled.
• This will enable the system administrator to quickly detect when the functions become
disabled and request a service call to correct the error.
Checking That Installation Is Complete:
Following the section "Checking the Security Version", display the version information of
the security chip from [Check Device Configuration] on the Control Panel, and show the
system administrator that "2.01" is displayed for the [Canon MFP Security Chip] item.
Checking That the Security Functions Are Enabled:
Request the system administrator to refer to the section "Checking the Security Mark" to
confirm that the security functions are enabled each time the host machine is started by
checking the security mark.
9 Installation > TYPE-3: HDD Data Encryption Kit/ Removable HDD Kit Installation Procedure > Informing the System Administrator That Installatio
9-145
) is
9-145