Canon imageRUNNER ADVANCE C3325 Series Service Manual page 840

■ Routing the Cable (when installing this equipment and other
options simultaneously)
• Routing the cable when installing the Copy Card Reader and other options simultaneously
is described below.
• Combinations are shown in the following table.
Voice Guidance Kit
Card Reader
9
Installation > Copy Card Reader-F1/Copy Card Reader Attachment Kit-B4 > Installation Procedure > Routing the Cable (when installing this equip
Voice Operation Kit
TYPE-1 TYPE-2
9 Installation > Copy Card Reader-F1/Copy Card Reader Attachment Kit-B4 > Installation Procedure > Routing the Cable (when installing this equip
● For TYPE-1 (When installing the Copy Card Reader and the Voice
Guidance Kit at the same time.)
1. Securing the Cable of the Voice Guidance
1) Remove the covers of the 4 Cord Guides, and affix the Cord Guides to the position as
shown in the figure.
2) Insert only the Speaker Cable through the 4 Cord Guides.
3) Install the 4 Cord Guide Covers.
2. Securing the Cable of the Copy Card Reader
1) Remove the covers of the 2 Cord Guides, and affix the Cord Guides to the position
T-9-5
as shown in the figure. (Use the Cord Guides (thick) included with the Copy Card
Reader.)
2) Remove the Face Seal, and install the Wire Saddle. (included with the Copy Card
Reader).
3) Fold the Copy Card Reader Cable at the [A] part, and insert only the Copy Card
Reader Cable through the 2 Cord Guides and then secure it in place with the Wire
Saddle.
4) Install the 2 Cord Guide Covers.
CAUTION:
• Do not cover the Exhaust Outlet with the Cord Guide.
• Do not affix a Cord Guide on the Reader Cable Cover.
7x
9-52
Reader Cable Cover
Wire Saddle
[A]
[B]
Exhaust Outlet
F-9-114
9-52