Initial Settings (Start Setup Guide) - Canon imageRUNNER 2525 Series Service Manual

1. Insert the connector of the supplied Power cord into
the AC inlet.
2. Install the supplied power cord clamp with the
supplied screw except for India model. Insert the left
leg of the power cord clamp into the machine frame.
NOTE:
Besides Australia model, use the TP screw (M3 x 6). For
Australia model, use the stepped screw.
1x
3. Plug the supplied Power cord in the wall outlet.
4. Peel off the protective seal from the operation panel.
Stepped Screw
TP
(M3x6)
(M3)
Initial Settings (Start Setup
Guide)
The Start Setup Guide screen appears when the power is
turned ON for the first time after the machine is installed.
Follow the instructions displayed on the display to configure
the settings of the Host Machine.
1. Turn ON the main power switch.
2. Perform the following basic setup items according
to the instructions displayed on the display.
• Language and country / region
• Mixing the toner
• Date & Time settings
• Fax settings
• IP address settings
NOTE:
The fax settings appear only when the optional Fax Board
is attached.
Checking the Print Image
1. Place a document on the document glass, copy it by
feeding paper from the cassette or manual-feed tray,
and then check the resultant print image.
• Check that no abnormal noise is heard.
• Check the image quality at respective
magnifications.
• Check that the document is copied normally on the
specified number of sheets.
319
9. Installation