Selecting An Area - JRC JAN-701B Instruction Manual

(Single view)
(Left Top view)
View 2
View 1
• Scale, Range, Motion mode, Azimuth mode can be set to each of View1 and View2.
• The following is displayed only in View1. It isn't displayed in View2.
･ Own ship's track, Plan route
･ Event mark, Information mark, Tide mark, Highlighting, Reference Point, Clearing Line, Cross
Bearing, LOP, AIS, TT, Radar overlay, User map
• It is canceled when changing View1/View2 during the following operation.
･ During EBL maneuver creating
･ During Make AZ
• Multi-view display is canceled when doing the following operation.
･ Starts the Route Planning
･ Starts the User Map Editor
･ Select Single View
• Manual Update is reflected in View1 and View2 both.
• As for the display panel one of the following, the value of active View in View1/View2 is displayed.
･ Range
･ Scale
･ Motion mode
･ Azimuth mode
Note:
• In View 2, the radar overlay, route, AIS/TT target ship symbols, own ship's track, user chart objects
and manual updates are not displayed.

3.11.2 Selecting an Area

A selected area will be displayed as view 2.
1) In the normal menu
Select [MENU] - [(6) Chart] - [(1) Multiview] - [(8) Select Area] in that order.
The cursor becomes the lens cursor.
2) If previous view mode was single view, the area selected with the lens cursor will be displayed
in the upper right of View1. If previous view mode was multi view, selected area in view1 is
displayed in view2.
(Top Bottom view)
View 1
View 2
(Right Bottom view)
View 1
View 2
3-87
(Right Left view)
View 1 View 2
(Left Bottom view)
View 1
View 2
3 Basic Operation of ECDIS
(Right Top view)
View 2
View 1
ECDIS