Highlight - JRC JAN-701B Instruction Manual

3.18.4 Highlight

You can use a polygon to highlight any parts of a chart. This function can be used when you wish to
make notations.
1) In the normal menu
Select [MENU] - [(6) Chart] - [(1) Marking/Highlighting] - [(4) Highlight] in that order.
In the Table Editing menu, Graphic Editing menu
Select [MENU] - [(5) Chart] - [(1) Marking/Highlighting] - [(4) Highlight] in that order.
In the User Chart Editing menu
Select [MENU] - [(4) Chart] - [(1) Marking/Highlighting] - [(4) Highlight] in that order.
The "Location/Attributes - Highlight" panel opens and the cross cursor changes to the
cursor.
2) Use the trackball to move the cursor to the part to be highlighted.
coordinates of a point which will be the starting point of the area to be highlighted.
3) In the "Location/Attributes - Highlight" panel, perform the following editing operation.
• Enter comment on the Highlight.
• You can edit the minimum scale and maximum scale that limit the display of the Highlight.
• To edit the Highlight position, left-click each column of LAT/LON.
The latitude and longitude entry panel opens. Enter the value and left-click the [OK].
• To fix the contents and close the panel, left-click the [OK].
You will see that the Highlight is put on the screen.
• Diagram is canceled when doing the left double-click when creating two points.
• Diagram is canceled when clicking the [OK] when creating two points.
• Diagram is canceled when clicking [Abort] from the context menu of the right-click when
creating two points.
• Diagram is fixed when doing the left double-click when creating more than three points and
the "Location/Attributes - Highlight" panel closes.
• Diagram is fixed when clicking the [OK] when creating more than three points and the panel
closes.
• Diagram is fixed when clicking [Abort] from the context menu of the right-click when creating
more than three points and the panel closes. Equal to or less than two point are canceled.
• When doing the following operation without ever clicking [Apply], diagram is canceled and
transitions to each mode.
･ Chooses [S-57/C-MAP/ARCS Information] from the context menu of right-click.
･Chooses [Other Information] from the context menu of right-click.
・Chooses [Auto Mode] from the context menu of right-click.
･ Chooses [Zoom Area] from the context menu of right-click.
･ Chooses [Dropped EBL/VRM] - [EBL1/VRM1 (or EBL2/VRM2)] from the context menu of
right-click.
･ Chooses [Dropped EBL/VRM] - [EBL1(or EBL2)] from the context menu of right-click.
･ Chooses [Dropped EBL/VRM] - [VRM1 (or VRM2)] from the context menu of right-click.
･ Chooses [CCRP EBL/VRM] - [EBL1/VRM1 (or EBL2/VRM2)] from the context menu of
right-click.
･ Chooses [CCRP EBL/VRM] - [EBL1 (or EBL2)] from the context menu of right-click.
･ Chooses [CCRP EBL/VRM] - [VRM1(or VRM2)] from the context menu of right-click.
• Diagram is fixed when clicking [Apply] once and doing the following operation and transitions
to each mode.
3-121 3 Basic Operation of ECDIS
ECDIS
Then, click on the