Startup Screen And Arcs Pin Input (Arcs Only) - JRC JAN-701B Instruction Manual

3.3.3 Startup Screen and ARCS PIN Input (ARCS
Only)
1) If ARCS has been installed, the "ARCS PIN" panel will be displayed after [Navigation & Planning]
is selected in the Startup menu. Input the ARCS PIN and left-click on the [OK] button. The
[Startup screen] will be displayed if the inputted ARCS PIN is correct and the [OK] button is
left-clicked on the "ARCS PIN" panel, or if the [Cancel] button has been left-clicked. If ARCS has
not been installed, however, the "ARCS PIN" panel will not be displayed. The [Startup screen]
will be displayed instead.
[Startup Screen]
3 Basic Operation of ECDIS
Note:
• ARCS will not be displayed unless a correct
ARCS PIN is inputted on the "ARCS PIN"
panel.
• ARCS will not be displayed if the [Cancel]
button is left-clicked on the "ARCS PIN"
panel.
• The "ARCS PIN" panel is displayed only
once after [Navigation & Planning] is
selected.
To show the "ARCS PIN" panel again after
left-clicking [Cancel], turn off the power of
ECDIS, and then, turn it on again to resume
the startup procedure.
• ARCS will not be displayed after its contract
term has expired.
Note:
• Use the software keyboard or PS/2
keyboard to input ARCS PIN.
• Be sure to carefully read the caution
displayed on the startup screen.
3-22