Table of Contents
Advertisement
(2) Displaying and clearing the EBL2/VRM2 marker
If you press the [EBL2] or [VRM2] key, the EBL2 or VRM2 marker with your ship as the base point,
and the EBL2/VRM2 information panel are displayed. These markers are displayed as a dash
dotted line to distinguish them from EBL1/VRM1. Each of these markers is controlled by turning
the EBL or VRM dial.
To clear the EBL2 marker or VRM2 marker:
Press the [EBL2] or [VRM2] key again.
(3) Switching EBL1/VRM1 marker and EBL2/VRM2 marker operations
The following describes how to switch operation when the EBL1 and EBL2, or VRM1 and VRM2
markers are simultaneously displayed. For example, let's assume that EBL1 and EBL2 are
displayed on the screen, and that EBL2 can be operated by the EBL dial. In this case, press the
[EBL1] key so that the EBL1 can be operated by the EBL dial. (See the next page)
These can be moved independently, such as EBL1 and VRM2 or EBL2 and VRM1.
The intersecting point positions in these cases will be displayed by combinations of the previously
displayed EBL1/VRM1 and EBL2/VRM2. When EBL and VRM are displayed independently, only
their bearing and distance will be displayed.
EBL
Turn EBL dial to
control EBL1
Note:
• For VRM1 and VRM2, use [VRM1] and [VRM2] key in the same way as for EBL1 and EBL2.
• They will be displayed as floating EBL/VRM while operating turning the EBL or VRM dial.
3 Basic Operation of ECDIS
[Display panel and chart (Operating EBL1 and VRM2)]
3-100
VRM
Turn VRM dial to
control VRM2
Advertisement
Table of Contents
