Four-Bay Lff Hot-Plug Drive Cage Option - HPE ProLiant ML150 Gen9 User Manual

Four-bay LFF hot-plug drive cage option

To install the component:
Unlock and remove the tower bezel
1.
Power down the server (on page 17).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
4.
Remove the access panel (on page 18).
5.
If installed, remove the PCI air baffle (on page 20).
6.
Remove the system air baffle (on page 22).
7.
Remove the fans (on page 23).
8.
Disconnect and remove the drive cage cable assembly:
9.
Disconnect the Mini-SAS cables and the power cable from the system board.
a.
Disconnect the drive cables from the rear of the drives.
b.
Remove the non-hot-plug drive cage.
10.
("Remove the tower bezel" on page 17).
Hardware options installation 82