Table of Contents
Advertisement
•
Server in rack mode: Install the server into the rack on page 53.
•
Server in tower mode: Return the server to an upright position.
18. Connect all peripheral cables to the server.
19. Connect each power cord to the server.
20. Connect each power cord to the power source.
21. Power up the server on page 23.
The installation is complete.
Installing the four-bay LFF hot-plug drive cage
The four-bay LFF hot-plug drive cage can be installed in both box 1 and box 2.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
Four-bay LFF hot-plug drive cage option
•
LFF hot-plug drive option
•
T-15 Torx Screwdriver
Procedure
1.
Power down the server on page 23.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
•
Server in rack mode: Remove the server from the rack on page 23.
•
Server in tower mode: Position the tower server for hardware configuration on page 25.
5.
Remove the access panel on page 25.
6.
Remove the front bezel on page 27.
7.
Remove the PCI air baffle on page 29.
8.
Remove the system air baffle on page 30.
9.
Disconnect all existing drive cage cables.
10. Remove the installed drive cage assembly.
Hardware options installation
65
Advertisement
Table of Contents
