Extend The Server From The Rack - HPE Apollo 4200 Gen10 Plus Maintenance And Service Manual

WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power supplies, and internal system WARNING:
components to cool before touching them.
WARNING: WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
The rack is bolted to the floor using the concrete anchor kit.
The leveling feet extend to the floor.
The full weight of the rack rests on the leveling feet.
The racks are coupled together in multiple rack installations.
Only one component is extended at a time. If more than one component is extended, a rack might become unstable.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-25 Torx screwdriver available.
Procedure Procedure
1. Pull down the quick release levers on each side of the server.
2. Loosen the screws behind both quick release levers.

3. Extend the server from the rack.

4. After performing the installation or maintenance procedure, slide the server back into the rack, and then press the server firmly into
the rack to secure it in place.
Remove the server Remove the server from the rack
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power supplies, and internal system WARNING:
components to cool before touching them.
WARNING: This server is heavy. To reduce the risk of personal injury or damage to the equipment: WARNING:
Observe local occupational health and safety requirements and guidelines for manual material handling.
Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened
from the rack
HPE Apollo 4200 Gen10 Plus Server Maintenance and Service Guide 20