Extend The Server From The Rack - HPE ProLiant DL380 Gen11 User Manual

Press and release the Power On/Standby button.
This method activates a controlled shutdown of applications and the OS before the server enters standby mode. It can also activate a
shutdown behavior governed by an OS configuration or policy.
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS. If an application stops
responding, you can use this method to force a shutdown.
Use a virtual power button selection through iLO.
This method initiates a controlled remote shutdown of applications and the OS before the server enters standby mode.
Before proceeding, verify that the server is in standby mode by observing that the system power LED is amber.

Extend the server from the rack

Extend the server from the rack
About this task About this task
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately stabilized before WARNING:
extending anything from the rack.
Procedure Procedure
1. Pull down the quick release levers on each side of the server.
2. If necessary, use a T-25 Torx screwdriver to loosen the shipping screws.
3. Extend the server from the rack.
HPE ProLiant DL380 Gen11 Server User Guide 38