Power Up The Server; Extend The Server From The Rack - HPE ProLiant ML30 Gen10 Maintenance And Service Manual

This method initiates a controlled shutdown of applications and the OS before the server enters standby mode.
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS. If an application stops
responding, you can use this method to force a shutdown.
Use a virtual power button selection through iLO 5.
This method initiates a controlled remote shutdown of applications and the OS before the server enters standby mode.
Before proceeding, verify that the server is in standby mode by observing that the system power LED is amber.
IMPORTANT: When the server IMPORTANT: When the
to the system to the system
IMPORTANT: IMPORTANT:
When the server is in standby mode, auxiliary power is still being provided to the system.

Power up the server

Power up the server
To power up the server, use one of the following methods:
Press the Power On/Standby button.
Use the virtual power button through iLO.

Extend the server from the rack

Extend the server from the rack
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
WARNING: WARNING:
To reduce the risk of personal injury or equipment damage, be sure that the rack is adequately stabilized before
extending a component from the rack.
4. Slide the server tray out of the rack:
a. Loosen the server tray thumbscrews.
b. Grasp the tray notch and slide the server out of the rack.
server is in standby mode, auxiliary power is still being provided is in standby mode, auxiliary power is still being provided
HPE ProLiant ML30 Gen10 Server Maintenance and Service Guide 30