Configuring Multi-Chassis Redundancy For Lag - Alcatel-Lucent 7450 Basic System Configuration Manual

===================================================
Synchronize Mode
Synchronize Status
Last Config Sync Time
Last Boot Env Sync Time : 2006/06/24 07:16:37
===================================================
A:ALA-12>config>system#

Configuring Multi-Chassis Redundancy for LAG

When configuring associated LAG ID parameters, the LAG must be in access mode and
LACP must be enabled.
Use the CLI syntax displayed below to configure multi-chassis redundancy features.
CLI Syntax:
Example:
Basic System Configuration Guide
: Configuration
: No synchronization
: 2006/06/27 09:17:15
config>redundancy
multi-chassis
peer ip-address
authentication-key [authentication-key | hash-
key] [hash | hash2]
description description-string
mc-lag
hold-on-neighbor-failure duration
keep-alive-interval interval
lag lag-id lacp-key admin-key system-id
no shutdown
no shutdown
source-address ip-address
sync
igmp
igmp-snooping
pim-snooping [sap]
port [port-id | lag-id] [sync-tag sync-
no shutdown
srrp
sub-mgmt
config>redundancy#
config>redundancy# multi-chassis
config>redundancy>multi-chassis# peer 10.10.10.2 create
system-id [remote-lag lag-id] system-
priority system-priority
tag]
range encap-range sync-tag sync-tag
System Management
309