Alcatel-Lucent 7450 Basic System Configuration Manual page 107

Context monitor>qos>arbiter-stats
Description This command monitors arbiter statistics for a SAP.
Parameters
sap-id — Specify the physical port identifier portion of the SAP definition.
arbiter name — Specify the name of the policer control policy arbiter. This parameter is
root — Specifies the scheduler to which this queue would be feeding.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
repeat repeat — Configures how many times the command is repeated.
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
subscriber
Syntax subscriber sub-ident-string [arbiter name | root] [ingress | egress] [interval seconds]
[repeat repeat] [absolute | rate]
Context monitor>qos>arbiter-stats
Description
This command monitors arbiter statistics for a subscriber and applies to the 7750 SR.
Parameters
sub-ident-string — Specifies an existing subscriber a identification policy name.
arbiter name — Specify the name of the policer control policy arbiter.
root — Specify the scheduler to which this queue would be feeding.
Basic System Configuration Guide
mandatory if the SAP resides on a LAG in adapt-qoslink or port-fair mode.
Values
An existing scheduler-name in the form of a string up to 32
characters long composed of printable, 7-bit ASCII characters. If
the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes.
Default
11 seconds
Values
11 to 60
Default
10
Values
1 to 999
processing. No calculations are performed on the delta or rate statistics.
instead of the delta.
Values
An existing scheduler-name in the form of a string up to 32
characters long composed of printable, 7-bit ASCII characters. If
the string contains special characters (#, $, spaces, etc.), the entire
string must be enclosed within double quotes.
CLI Usage
107