Alcatel-Lucent 7450 Basic System Configuration Manual page 479

Basic System Configuration Guide
Table 50: Show NTP Field Description (Continued)
Label
Remote
Reference ID
Reference ID (cont.)
St
Description (Continued)
The IP address of the remote NTP server or peer with which this local host
is exchanging NTP packets.
When stratum is between 0 and 15 this field shows the IP address of the
remote NTP server or peer with which the remote is exchanging NTP
packets. For reference clocks, this field shows the identification assigned
to the clock, such as, ".GPS." For an NTP server or peer, if the client has
not yet synchronized to a server/peer, the status cannot be determined and
displays the following codes:
Peer Codes:
ACST — The association belongs to any cast server.
AUTH — Server authentication failed. Please wait while the association
is restarted.
AUTO — Autokey sequence failed. Please wait while the association is
restarted.
BCST — The association belongs to a broadcast server.
CRPT— Cryptographic authentication or identification failed. The details
should be in the system log file or the cryptostats statistics file, if
configured. No further messages will be sent to the server.
DENY — Access denied by remote server. No further messages will be
sent to the server.
DROP — Lost peer in symmetric mode. Please wait while the association
is restarted.
RSTR — Access denied due to local policy. No further messages will be
sent to the server.
INIT — The association has not yet synchronized for the first time.
MCST — The association belongs to a manycast server.
NKEY — No key found. Either the key was never installed or is not
trusted.
RATE — Rate exceeded. The server has temporarily denied access
because the client exceeded the rate threshold.
RMOT — The association from a remote host running ntpdc has had
unauthorized attempted access.
STEP — A step change in system time has occurred, but the association
has not yet resynchronized.
System Codes
INIT — The system clock has not yet synchronized for the first time.
STEP — A step change in system time has occurred, but the system clock
has not yet resynchronized.
Stratum level of this node.
System Management
479