Alcatel-Lucent 7450 Basic System Configuration Manual page 135

Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters neighbor ip-address — The IP address to display information for entries received from the
interval seconds — Configures the interval for each display in seconds.
repeat repeat — Configures how many times the command is repeated.
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
Output
Sample Output
A:ALA-12>monitor>router# ospf neighbor 10.0.0.104 interval 3 repeat 3 absolute
===============================================================================
Monitor statistics for OSPF Neighbor 10.0.0.104
===============================================================================
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
Bad Nbr States
Bad Seq Nums
Bad Packets
Option Mismatches: 0
-------------------------------------------------------------------------------
At time t = 3 sec (Mode: Absolute)
-------------------------------------------------------------------------------
Bad Nbr States
Bad Seq Nums
Bad Packets
Option Mismatches: 0
-------------------------------------------------------------------------------
At time t = 6 sec (Mode: Absolute)
-------------------------------------------------------------------------------
Bad Nbr States
Bad Seq Nums
Bad Packets
Option Mismatches: 0
-------------------------------------------------------------------------------
At time t = 9 sec (Mode: Absolute)
-------------------------------------------------------------------------------
Bad Nbr States
Bad Seq Nums
Basic System Configuration Guide
specified OPSF neighbor. Up to 5 IP addresses can be specified.
Default
5 seconds
Values 3 to 60
Default 10
Values
1 to 999
processing. No calculations are performed on the delta or rate statistics.
instead of the delta.
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
LSA Inst fails : 0
Bad MTUs : 0
LSA not in LSDB : 0
Nbr Duplicates : 0
LSA Inst fails : 0
Bad MTUs : 0
LSA not in LSDB : 0
Nbr Duplicates : 0
LSA Inst fails : 0
Bad MTUs : 0
LSA not in LSDB : 0
Nbr Duplicates : 0
LSA Inst fails : 0
Bad MTUs : 0
CLI Usage
135