System Information Parameters
Name
Use the system command to configure a name for the device. The name is used in the prompt
string. Only one system name can be configured, if multiple system names are configured the
last one encountered overwrites the previous entry. Use the following CLI syntax to configure
the system name:
CLI Syntax:
Example:
The following example displays the system name:
sysName@domain>config>system# info
#------------------------------------------
echo "System Configuration "
#------------------------------------------
. . .
----------------------------------------------
sysName@domain>config>system#
Contact
Use the contact command to specify the name of a system administrator, IT staff member, or
other administrative entity.
CLI Syntax:
Example:
Location
Use the location command to specify the system location of the device. For example, enter
the city, building address, floor, room number, etc., where the router is located.
Use the following CLI syntax to configure the location:
Basic System Configuration Guide
config>system
name system-name
alcatel>config>system# name ALA-12
name "ALA-12"
exit
config>system
contact contact-name
config>system# contact "Fred Information Technology"
System Management
293