Alcatel-Lucent 7450 Basic System Configuration Manual page 84

Basic CLI Command Reference
Parameters card slot-number — Specifies the slot number associated with the queue group, expressed as an
fp fp-number — Specifies the FP number associated with the queue group, expressed as an
ingress — Displays policer statistics applied on the ingress FP.
access — Displays policer statistics on the FP access.
network — Displays policer statistics on the FP network.
queue-group queue-group-name — Specifies the name of the queue group up to 32 characters in
instance instance-id — Specifies the identification of a specific instance of the queue-group.
interval interval — Configures the interval for each display in seconds.
repeat repeat — Configures how many times the command is repeated.
policer policer-id — The specified policer-id must exist within the queue-group template applied
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
percent-rate — When the percent-rate keyword is specified, the rate-per-second for each statistic
reference-rate — When a reference-rate value is specified, the rate-per-second for each statistic is
ccag
Syntax ccag ccag-id [path {a | b}] [type {sap-sap | sap-net | net-sap}] [interval seconds] [repeat
repeat] [absolute | rate]
84
integer.
Values 1 to 20
integer.
Values
1 to 2
length.
Values
1 to 65535
Default
11 seconds
Values
11 to 60
Default
10
Values 1 to 999
to the ingress context of the forwarding plane.
Values 1 to 8
processing. No calculations are performed on the delta or rate statistics.
is displayed based on the reference rate of 10G.
Default
10
Values 1 to 999
displayed as a percentage based on the reference rate specified.
Values
100M, 1G, 10G, 40G, 100G, 400G
Basic System Configuration Guide