Alcatel-Lucent 7450 Basic System Configuration Manual page 536

Show, Clear, Debug, and Tools Command Reference
This command also affects the BITS output port on the active CPM. If the BITS output port selection
is set to line-reference and the reference being forced is not the BITS input port, then the system uses
the forced reference to generate the signal out the BITS output port. If the BITS output port selection
is set to internal-clock, then the system uses the output of the CPM clock to generate the signal for the
BITS output port.
On a CPM activity switch, the force command is cleared and normal reference selection is determined.
Debug configurations are not saved between reboots.
The 7750 SR-c4 has two BITS input ports on the CFM. The force reference command on this system
allows the selection of the specific port.
7750 SR-c4 CLI Syntax: debug>sync-if-timing>force-reference {ref1 | ref2 | bits | bits1 | bits a |
bits b}
Parameters
ref1 — The clock will use the first timing reference.
ref2 — The clock will use the second timing reference.
bits — The clock will use the external network interface on the active CPM to be the highest
bits1 — (7750 SR-c4) The clock will use the bits1 timing reference.
bits2 — (7750 SR-c4) The clock will use the bits2 timing reference.
bitsa — The clock will use the bitsa timing reference.
bitsb — The clock will use the bitsb timing reference.
ptp — The clock will use the PTP slave as the timing reference (applies to the 7450 ESS and
system
Syntax [no] system
Context debug
Description
This command displays system debug information.
http-connections
Syntax http-connections [host-ip-address/mask]
http-connections
Context debug>system
Description This command displays HTTP connections debug information.
Parameters
host-ip-address/mask — Displays information for the specified host IP address and mask.
536
priority input.
7750 SR).
Basic System Configuration Guide