Alcatel-Lucent 7450 Basic System Configuration Manual page 339

Parameters retries — Specify the number of failed loopback attempts before an ATM VC goes down.
retry-up
Syntax retry-up retries
no retry-up
Context config>system>atm>oam
Description
This command specifies the number of consecutive OAM loopback attempts that must succeed after
the periodic attempt before the endpoint will transition the state to up. This command only applies to
the 7750 SR.
Parameters retries — Specify the number of successful loopback replies before an ATM VC goes up.
boot-bad-exec
Syntax boot-bad-exec file-url
no boot-bad-exec
Context config>system
Description Use this command to configure a URL for a CLI script to exec following a failure of a boot-up
configuration. The command specifies a URL for the CLI scripts to be run following the completion
of the boot-up configuration. A URL must be specified or no action is taken.
The commands are persistent between router (re)boots and are included in the configuration saves
(admin>save).
Related Commands
exec
console.
Default
no boot-bad-exec
Parameters
file-url — Specifies the location and name of the CLI script file executed following failure of the
Basic System Configuration Guide
Values
0 to 10 (A zero value means that the endpoint will transition to
AIS-LOC state immediately if the periodic loopback attempt
fails.)
Default 4
Values
0 to 10 (A zero value means that the endpoint will transition to the
up state immediately if the periodic loopback attempt succeeds.)
Default
2
- This command executes the contents of a text file as if they were CLI commands entered at the
boot-up configuration file execution. When this parameter is not specified, no CLI script file
is executed.
System Management
339