Alcatel-Lucent 7450 Basic System Configuration Manual page 341

Ethernet service switch /service router /extensible routing system
Hide thumbs Also See for 7450:
Table of Contents

Advertisement

chassis-mode
Syntax
chassis-mode [chassis-mode] [force]
Context
config>system
Description
This command configures the chassis scaling and feature set and only applies to the 7450 ESS and
7750 SR.
Note that, if you are in chassis-mode d and configure an IOM type as iom2-20g and then downgrade
to chassis-mode a or b (must specify force keyword), a warning appears about the IOM downgrade.
In this case, the IOM provisioned type will downgrade to iom-20g-b. Once this is done, the ASAP
MDA cannot be configured.
The ASAP MDA can only be configured if the iom2-20g IOM type is provisioned and equipped and
the chassis mode is configured as a or b.
If this is the desired behavior for the 7750 SR, for example, chassis-mode d is configured and IPv6 is
running, you can then downgrade to chassis-mode a or b if you want to disable IPv6.
For chassis mode d, the default must be changed from the default mode a which assumes the least
available features. Mode d enables the new feature sets available with newer generations of IOMs.
Chassis mode d supports the P2/Q2/T2-based IOMs products and the extensive queuing/policing/
bandwidth. Mode d assumes that the iom3-xp is installed.
The force command is not available for chassis-mode d.
Default
a
Parameters
chassis-mode — Specify the one of the following chassis modes:
Basic System Configuration Guide
cflash-id
a: This mode corresponds to scaling and feature set associated with iom-20g.
b: This mode corresponds to scaling and feature set associated with iom-20g-b.
c: This mode corresponds to scaling and feature set associated with iom2-20g (7750 SR only).
d: This mode corresponds to scaling and feature set associated with iom3-xp.
remote-locn
ipv4-address
ipv6-address
cf1:, cf1-A:,cf1-B:,cf2:,cf2-A:,cf2-B:,cf3:,cf3-A:,cf3-B:
System Management
[hostname | ipv4-address | [ipv6-
address]]
a.b.c.d
x:x:x:x:x:x:x:x[-interface]
x:x:x:x:x:x:d.d.d.d[-interface]
x - [0..FFFF]H
d - [0..255]D
interface - 32 chars max, for link
local addresses
341

Advertisement

Table of Contents
loading

This manual is also suitable for:

77507950

Table of Contents