System Command Reference
Parameters
interval — Specifies the LLDP transmit interval time.
LLDP Ethernet Port Commands
lldp
Syntax
lldp
Context
config>port>ethernet
Description
This command enables the context to configure Link Layer Discovery Protocol (LLDP) parameters on
the specified port.
dest-mac
Syntax
dest-mac {bridge-mac}
Context
config>port>ethernet>lldp
Description
This command configures destination MAC address parameters.
Parameters
bridge-mac — Specifies destination bridge MAC type to use by LLDP.
admin-status
Syntax
admin-status {rx | tx | tx-rx | disabled}
Context
config>port>ethernet>lldp>dstmac
Description
This command specifies the administratively desired status of the local LLDP agent.
Parameters
rx — Specifies the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
tx-rx — Specifies that the LLDP agent will transmit and receive LLDP frames on this port.
452
Values
1 to 100
Default
5
Values
nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port
MAC Relay (TPMR).
nearest-customer — Specifies to use the nearest customer.
information about the remote systems connected.
Basic System Configuration Guide