Alcatel-Lucent 7450 Basic System Configuration Manual page 203

The following example displays an example of the output when the boot sequence is
interrupted.
. . .
Hit a key within 3 seconds to change boot params...
You must supply some required Boot Options. At any prompt, you can type:
Press ENTER to begin, or 'flash' to enter firmware update...
Software Location
-----------------
The existing Image URL is 'ftp://vxworks:vxw0rks@192.168.xx.xxx/./rel/0.0/xx'
Press ENTER to keep it.
Software Image URL:
Using: 'ftp://vxworks:vxw0rks@192.168.xx.xxx/./rel/0.0/xx'
Configuration File Location
---------------------------
The existing Config URL is 'cf3:/config.cfg'
Press ENTER to keep it, or the word 'none' for no
Config File URL:
Using: 'cf3:/config.cfg'
Network Configuration
---------------------
The existing Active IP address is 192.168.xx.xxx/20. Press ENTER to keep it.
Basic System Configuration Guide
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
You must enter the URL of the TiMOS software.
The location can be on a Compact Flash device,
or on the network.
Here are some examples
cf3:/timos1.0R1
ftp://user:passwd@192.168.xx.xxx/./timos1.0R1
tftp://192.168.xx.xxx/./timos1.0R1
You must enter the location of configuration
file to be used by TiMOS.
a Compact Flash device, or on the network.
Here are some examples
cf1:/config.cfg
ftp://user:passwd@192.168.xx.xxx/./config.cfg
tftp://192.168.xx.xxx/./config.cfg
You specified a network location for either the
software or the configuration file.
assign an IP address for this system.
The IP address should be entered in standard
dotted decimal form with a network length.
example: 192.168.xx.xxx/24
The file can be on
You need to
Boot Options
Config URL.
203